How do you turn on the rear wiper on a Chevy Traverse

To turn the rear wiper on or off click the top of the button. To spray washer fluid on the rear window click the bottom of the lever.

Why is my rear windshield wiper not working?

The most common electrical problem in your windshield wiper system is a blown fuse so that’s a good place to start. The fuse will most likely be in the main fuse block under the hood. Other problems could include a burnt out wiper motor, a problem with the wiper control switch or a problem with the delay module.

How do you turn off the rear windshield wiper on a 2017 Chevy Traverse?

To turn the system on or off, go to the Vehicle Information menu in the Driver Information Center. See Driving and Operating in your Owner Manual. Press the top of the switch to turn the rear wiper on or off.

How do you turn on windshield wipers on a Chevy Equinox?

The windshield wiper/washer lever is located on the right side of the steering column. With the ignition in ACC/ACCESSORY or ON/RUN/ START, move the windshield wiper lever to select the wiper speed. HI: Use for fast wipes.

How does the wiper switch work?

How the wiper system works: when you turn the wiper on, the wiper switch sends the signal to the control module. The control module operates the wiper relay. The relay sends 12-volt power to the wiper motor. … The motor rotates a little arm (see the diagram) that through links moves the wiper arms.

How do you test a rear wiper relay?

Check for voltage input to the rear wiper relay by removing the relay from the panel and measuring voltage at the appropriate socket terminals with the ignition on. If there is voltage input to the relay but no voltage reaching the motor, then the relay is faulty and should be replaced.

Where is the wiper relay?

Internal Relay In some vehicles, the wiper relay switch is inside the actual windshield wiper motor. If it fails, the entire motor needs to be replaced, as you can’t get parts to fix it.

How do you turn on the rear windshield wiper on a 2011 Chevy Traverse?

To turn the rear wiper on or off click the top of the button. To spray washer fluid on the rear window click the bottom of the lever.

How do you turn off the rear wiper on a Touareg?

You’ll see the wiper lever to the right of Your steering wheel. To engage the rear windshield wiper, You’ll press the lever outward (toward the dashboard) one notch. To turn it off, You’ll pull it back towards You, into the “OFF” position.

How do you turn off the rear wiper on a 2010 Chevy Traverse?

Press the top of the switch to turn the rear wiper on or off. Press the bottom of the switch to spray washer fluid on the rear window. See Instruments and Controls in your Owner Manual. Press the Power Liftgate OFF switch to turn off the power liftgate.

Article first time published on

How do you turn off rain sensing wipers on a Chevy Tahoe?

Move the windshield wiper lever to AUTO. …
Turn the Rainsense sensitivity band UP for more sensitivity to moisture.
Turn the Rainsense sensitivity band DOWN for less sensitivity to moisture.
Move the lever out of AUTO to cancel Rainsense.

Where do you put the washer fluid in a Chevy Equinox?

Open the washer reservoir cap by lifting it up. On most Chevrolet vehicles, the window fluid reservoir is located on the driver side towards the front and behind the headlight. Add washer fluid until the level gets about two inches below the reservoir cap.

Why is my wiper motor not working?

The wiper motor is not working. When a windshield wiper is not working, it could mean that the electrical motor inside the wiper shorted out or malfunctioned. This means that your wipers won’t work at all. … You can try replacing any worn parts, but the easiest thing might be just to replace your wipers.

How do you turn on the rear windshield wiper on a Hyundai Palisade?

The rear window wiper and washer switch is located at the end of the wiper and washer switch lever. Turn the switch to the desired position to operate the rear wiper and washer. Push the lever away from you to spray rear washer fluid and to run the rear wipers 1~3 cycles.

How do you lift windshield wipers on i30?

Within 20 seconds of turning off the engine, move the wiper lever down and hold it to the. …
At this time you can lift the wipers off the windscreen.

How do I know if my wiper relay is bad?

The windshield wiper blades have one speed.
The windshield wiper blades don’t work.
Wiper blades operate at speeds different than you selected.
Humming noise when the wipers are on.

What is the wiper relay?

The Windshield Wiper Motor Relay is a part of your windshield wiper system. It controls the voltage input to the wiper motor. The relay senses the position of the wipers and transmits power to the wipers they are in their parked position.

How do I know if my wiper switch is bad?

Common signs include windshield wipers not turning on or off, not changing speed or settings, and the turn signals not working.