Do I need a permit to extend my driveway

A driveway permit is usually a requirement of a land use process or building permit. … A driveway permit is required for any new or altered access to a county road.

Do you need permission to widen your driveway?

Widening Your Driveway In the most part, a drive widening projectin in itself will not require planning permission. However if the widening project involves demolishing part or even all of a boundary fence or wall fronting a highway then this will require planning permission.

Can you widen an existing asphalt driveway?

If you need to accommodate an additional driver or larger vehicles, widening a driveway is a simple solution if your existing pavement is too narrow. Whether the existing driveway is paved with asphalt, concrete or another material, using pavers for the expansion adds contrast and style.

Can I extend the width of my driveway?

Pavers are the Most Cost-Effective Way to Extend Your Driveway. No matter how your current driveway is made, if you want to extend it without breaking the bank, permeable pavers from TRUEGRID are the way to go.

Does a double driveway add value?

You may be surprised to learn that a driveway does add value to your home. On estimate a driveway can increase your property’s value by 5-10%.

Can you concrete over asphalt driveway?

Yes, you can pour concrete over an asphalt driveway. While asphalt provides a poor bond with concrete, it does serve as an excellent base as it is solid, stable, and very strong. Provided the asphalt is in decent condition, there is no reason you can’t pour concrete over the top.

How do I extend my driveway with pavers?

1. Measure the height of the concrete pavers. …
2. Dig out the driveway extension area to the depth indicated by your measurements. …
3. Spread 6 inches of crushed rock over the dug-out area. …
4. Lay plastic edge restraints along the perimeter of the paver area, setting them on top of the rock base.

How much does it cost to replace expansion joints?

The price to repair expansion joints and control joints greatly depends on how bad the damage is. Preventative joint filling can cost between $1.50 and $3 per lineal foot, but once expansion joint repair or control joint repair is required, the costs can vary from $15 – $100 per lineal foot of joints.

What is a permeable driveway?

A permeable driveway allows for water to naturally pass through its surface so it can be safely drained away through the sub-base. They have become increasingly popular with homeowners because new or replacement permeable driveways do not require planning permission, regardless of their size.

Do I need expansion joints in concrete driveway?

Every concrete slab, inside (basements, garages, etc.) or outside (driveways, patios, entries, etc.) are required to have joints every eight feet horizontally and vertically. Expansion Joints provide space between concrete slabs as a buffer for expansion on hot days and contraction when it is cold.

Article first time published on

Can you replace expansion joints in concrete?

After a while, the expansion joint can dry out and won’t absorb the stress as well as it once did. That’s when cracks appear in the concrete slabs. When this occurs, it’s time to replace the expansion joints. … This will help the new material to bond to the old concrete.

What is the cheapest way to lay a driveway?

Gravel and Stone Driveways A gravel driveway is by far the cheapest and quickest to install, especially if the existing driveway sub-base is sound.

What adds house value?

Making your house more efficient, adding square footage, upgrading the kitchen or bath and installing smart-home technology can help increase its value.

Does off street parking increase home value?

Does off-street parking translate to added property value? In short, yes. Having off-street parking can be a tremendous asset, with some reports stating that properties with their own parking facilities can fetch up to 13 per cent more than similar homes without.

Can you pour new concrete next to old concrete?

Many large slabs are split into several separate pours on different days. … And you can’t just pour two slabs next to each other and have them meet the structural requirements of your project; you must join the two concrete slabs in the proper way.

How much does it cost to extend a concrete slab?

On average, a basic concrete slab costs $6.60 per square foot to install, not including detailed finishes, designs, or reinforcements. A 4-inch concrete slab averages around $5.35 per square foot, while a 6-inch concrete slab typically costs $6.19 per square foot.

Can you put concrete over old concrete?

You can put new concrete over old concrete. However, unresolved issues with your old concrete, such as cracks or frost heaves, will carry over to your new concrete if not taken care of. In addition, you must pour it at least 2 inches thick.

Can you put pavers over driveway?

Brick paving can be installed over existing concrete or asphalt as long as it is in reasonably good shape. To ensure an adequate foundation for the brick, the existing concrete slab or asphalt should be inspected and repaired as necessary.

Is an asphalt driveway cheaper than concrete?

Cost. The cost of an asphalt driveway is typically cheaper than concrete, costing $2.00 – $4.00 per square foot. Asphalt prices tend to fluctuate with fluctuations in crude oil prices. In contrast, a concrete driveway costs between $4.00 – $6.00 per square foot for a standard installation.

Can you mix asphalt and concrete?

Finally, concrete is great for reinforcing the base of an asphalt lay. Whether you’re starting with a base of pure concrete, or using a custom asphalt-concrete mix, this is often a cost-effective option for creating asphalt surfaces capable of standing up to heavy usage.

Can you fill asphalt cracks with concrete?

Concrete can be used to patch almost any crack in an asphalt driveway. … Any deep cracks or sizeable holes you must add gravel up to four inches from the surface, then pour in the concrete and tamp it down using a magnesium float. Finish it with a broom or flat trowel so that it blends with the asphalt driveway finish.

Do you need planning permission to replace a driveway?

When Will You Need Planning Permission for Your Driveway? In simple terms, you won’t need planning permission if you intend your new driveway (regardless of its size) to use permeable or porous surfacing that allows liquid (such as rainwater) to drain through.

Can you turn your front garden into a driveway?

Yes, you can convert your front garden into a paved driveway, and doing so can add 5% to 10% to the overall value of your property depending on your area, but there are some certain things to consider before proceeding including planning permission, conservation area rules and laws surrounding dropped kerbs.

Do I need building regs for a driveway?

Generally a new driveway or patio area does not require building regulations approval. However, you will need to make sure that any alterations do not make access to the dwelling any less satisfactory than it was before.

How much does it cost to caulk an expansion joint?

Prices for professional pool expansion joint caulking runs $5.00 – $8.00 per linear foot. Measure or add up the perimeter of the pool to figure your price. The range in price depends on the width of the joint, which is usually 1/2″ – 1″, or regional differences in pricing.

What is a roof expansion joint?

An expansion joint cover is what you see on a roof, and it allows the roof membrane to expand and contract in sync with the roof deck, without compromising the roof system.

What is the difference between expansion joints and control joints?

In building materials, a control joint is used to control cracking while an expansion joint is designed to handle structural movement. … A control joint can be formed during placement of the building material or cut after the material is placed.

How far apart should expansion joints be in concrete driveway?

Usually, expansion joints should be no farther apart than 2 to 3 times (in feet) the total width of the concrete (in inches). So for a 4 inch thick concrete slab, expansion joints should be no more than 8 to 12 feet apart.

Do you have to fill concrete joints?

All joints need to be honored and should not be filled flush with the coating. After the coating has cured, a commercial quality flexible joint sealer should be used for the perimeter expansion joints. These joints will expand and contract with the weather and is why such a sealer is needed.