How do you remove metal fence posts from concrete

Answer Not Found

Can you reuse metal fence posts with concrete?

Pulling up an existing fence post to reuse can be quite a task. … Posts with concrete at the base are the most difficult to remove and reuse because the concrete base is larger than the post, which makes pulling it up through the ground much harder.

How do you remove concrete from fence post holes?

Break the concrete footing into two or more sections, using a cold chisel and steel mallet. Drive the tip of the chisel into the seam between the base of the post and top of the concrete until the concrete breaks. Repeat this on the opposite side of the post.

How do you remove a wrought iron fence?

1. Locate the bolts attaching the wrought iron fence section to the support post. …
2. Loosen the bolts attaching the fence section to the support post on each end of the section with a socket wrench. …
3. Remove the bottom bolts on each end of the fence section completely.

How do you remove a fence post without a jack?

If you don’t have scrap lumber, you can use a spade bit to drill a hole in the side of the post, large enough to insert the pry bar and get leverage. Another option is to drill a hole clean through the post, with a diameter big enough to slide your bar through.

How do you use a post puller plate?

Place a chain hook through the chain hole or loop. Place the T-Post Puller around the t post, and pull the t post out. No more chain slipping off or wrapping the chain around the t posts every time. Simply slide around the t post post and pull up.

What is post puller?

SpeeCo S16110400 Metal T-Post Puller; Allows the T Post To Be Removed From the Ground with a Tractor Bucket, Chain, Handyman Jack or a S Hook; Allows the Use of Different Gauges of Chain; Easy and Quick To Use.

How do you remove wrought iron from concrete?

1. Clear the area around the railings. Clear the entire area around the wrought iron railings to have as much room to work with as possible. …
2. Identify the type of fasteners and remove them. …
3. Pry the railing loose from the cement. …
4. Dispose of the old wrought iron railings.

Can you reuse metal fence posts?

Whether the fence is over your property line, or maybe the fence was installed badly, you can actually pull chain link fence posts and reuse them. … Just be sure to avoid damaging the posts if you try to remove the concrete anchor that holds them in place.

How do you replace wrought iron porch columns?

1. Choose new posts to replace the old ones. …
2. Insert a temporary support post between the porch ceiling and the porch floor a few feet from the post you are removing. …
3. Remove the old wrought iron porch post. …
4. Measure the distance between the porch ceiling and the floor.
5. Cut off the new porch post to the right length.

Article first time published on

How do you remove old concrete footings?

1. Ensure that the structure is supported, remove the footing post if applicable.
2. Using a spade shovel manually excavate around the footing at least 3/4 the way around and at least 2/3rds of the length of the footing.
3. Dig until you see the footing wiggle a bit.